CAD

How It Works !

Step 1. - Create the Relief

Start with creating a preferred relief, which will be under the grip. Use rings between fingers or simply apply grip over the old tape job.

Step 2. - Center

Use your thumb to center the grip in the middle of the ice hockey stick, hold it until Step 4.

Step 3. - Leave 1 cm

It is important to leave around 1cm from the knob out before applying the heat to the ice hockey grip

Step 4. - Start from the Top

First and foremost you have to start from the knob side, remember to hold your thumb as long as top has shrunken fully and is fixed.

Step 5. - Slowly Rotate

When applying the grip, slowly rotate the hockey stick, it should shrink on all sides equally

Step 6. - You are Ready

Lastly let it cool down for a few minutes and you are ready to hit the ice

Frequently asked questions

It is also possible to apply Griprush over already existing tape job, with doing so Griprush will shrink and fit in form of your old tape job, this is preferred way if you don’t want to change the feeling you are already familiar with.

Griprush should last till your stick brakes, but be aware that if you step on it with skate, it may be cut and this therefore might lead to the fact that Griprush fails to last that long.

Grip lasts only till stick brakes, it cannot be taken off and used again.

It depends on how big is the knob of the stick, if it is bigger than 4.2CM in diameter you will not be able to use it over the knob, however still the grip can be installed on the stick part, afterwards applying over it the knob with tape.

In case if your grip is too loose, we would advise you to use heat gun for second application. It has higher temperature and grip should shrink as much as it can and then there must be no problems. However, please, watch the installation video and read the instruction carefully!